ASA Alloys is a leading Canadian distributor with a large selection of specialty metal products in the forms & sizes you need, ready for when you need them. In aluminum alloys we offer sheet, coil, plate, pipe, channels, angles, tees, I beams and round, square & flat bar and round, square & rectangular tube.
Aluminum piping and tubing is silvery-white, soft, and ductile. The metal belongs to the boron group. Aluminum is the third most abundant element present on earth. Aluminum has low density. When exposed...
The term "aluminum coil" describes aluminum that has been flattened into sheets where their width is significantly higher than their thickness and then "coiled" into a roll. Stacks of individual aluminum sheets are difficult to...
Aluminum is the most abundant metal on the Earth’s crust, but it rarely exists as an elemental form. Aluminum and its alloys are valued because of their low density and high strength-to-weight ratio, durability, and corrosion resistance...
An aluminum channel is a structurally sound metal component that is made by the extrusion process to produce shapes, forms, and designs for a wide variety of applications. The major benefit of aluminum channels is their weight, which is...
Extruded aluminum is a continuous piece of aluminum that usually has a constant profile or cross-section throughout its length. It is made by forcing a block of aluminum, called a billet, through a die opening which is smaller than the original cross-sectional area of the billet...
Aluminum trim is an aluminum product that is produced by extrusion to create long, narrow, pliable, and adaptive pieces of aluminum that can be used for architectural decorative applications and accents, indoor and outdoor lighting, and engineering design...
Copper is a ductile, malleable, and reddish-gold metal with the capacity to effectively conduct heat and electricity. Brass and bronze, two commonly used alloys, are created when copper is combined with...
Titanium metal, with the symbol Ti, is the ninth most abundant element on the earth’s crust. It does not occur in large deposits, yet small amounts of titanium are found in almost every rock. Titanium is a shiny gray metal with...
Stainless steel can be fabricated using any of the traditional forming and shaping methods. Austenitic stainless steel can be rolled, spun, deep drawn, cold forged, hot forged, or stippled using force and stress...
